Thread: Tunnel Ram Problems
-
08-10-2005 06:44 PM #1
Tunnel Ram Problems
Hey guys, I am new here.
I have a chevy 350 with an Edelbrock tunnel ram with 2 Edelbrock 500 CFM carbs.
Idles great for about 4 minutes at about 1100 rpm then ramps up to about 2200rpm and the temp shoots up, I have not let it go past 190 degrees............
Any thoughts were to start?Burn em if you got em
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
08-10-2005 08:52 PM #2
Idle speed increase with heating points to a vacuum leak, but why it runs good for a few minutes beats me. Something heating up and opening up a leak, I suppose.
-
08-11-2005 05:28 PM #3
will check that out, how about the motor back peddling when shutting off?Burn em if you got em
-
08-11-2005 05:53 PM #4
If its idling fast and you shut it off, enough gas/air is getting in to fire without spark. It will run either way under those conditions.
-
08-15-2005 08:20 AM #5
Thanks very much, I am checking that out today.Burn em if you got em
Great to see your new post, Mike, and great to see CHR up and running again after several days of the Hmmm, can't reach this page.... Also good that you found an easy solution to your storage/access...
1968 Plymouth Valiant 1st Gen HEMI