Thread: 200 I6 build pics on the way

Tweet

here is the flange for the turbo outlet. this is 2" exhaust pipe with the slip over flare on it, pressed into a 2" 3 bolt exhaust flange, which I then welded for security with a 110 arc welder using 60/13 rod. then I sanded the bottom down with a belt sander until it was leval. the pic is a little blurry because I actully had to extract a pic from a movie ( hooked it to the computer and started capturing ), had some diffaculty with the camera in taking pics without the flash ( cant figure out how to turn it off ) and as with all digi cams my faimily has had that utalized CMOS sensors, too much light will cause the picture to go white, and that was happening to me.

oh yeah, I have to drill 1 hole into a slot so I can fit it to the bolt pattern of the turbo, it's slightly off.