Thread: Is my engine overheating?

Tweet

I think you should consider an air scoop or vent holes and try and get it around 180 deg. then you know that your motor is not to hot at all. and about the tranny I would take it in and have it rebuilt.

Are you sure your fuel pump is not vapor locking or going bad? What temperature thermostat are you using for your radiator? It should be about a 160 degrees. If that doesn't work you might wanna try a set of water restrictors in place of your thermostat. I had this problem with a bored out 302 that I had built. It would over heat and die. The water restrictors fixed the problem these pieces are just like big washers with different size hole cut in them and they dont stop the water flow they just restrict it to where its slow enough to cool the engine down. You usually get three of them in the set try the middle size first. See if this helps your problem.


~ Vegas ~

Hmmmm, maybe try driving without a gas cap and the tank only half full so it doesn't spill. I am thinking that just maybe you do not have a breather vent on the fuel tank. If that isn't it, replace the fuel filter and check the pressure of the fuel pump at idle. It may be that the pump is on it's last leg.

As for the tranny, check your vacuum line going to the tranny and if that is ok, change the vacuum regulator. These are all cheap fixes.

Thanks for all the help guys... Ill check up on all ur suggestions and see if ne of that works.

The new gas formulas suck and lead to vapor lock a lot earlier..
I would suggest that 200 degree's is ok in and by itself.
The max temp allowed would have more to do with what thje max temp the oil can handle tp lube the critical parts. But if you super insulate everything, make sure you don't hold that heat in....
You be best off to develop ways to remove the heat to a place where it won't hurt you...convection, be it water, air, oil, or metal is all the same....just the rate changes..
Jeff

Originally posted by rebel8324
How hot is too hot for an engine? I seem to be having a problem and im not sure if its too to excessive heat. When my engine reaches around 200F or so it will begin to act wierd and suddenly dies. This only happens when im standing still though. The engine starts back up in a couple of seconds of waiting. Im not sure wut could be causing this. Could it be the carburetor or what? I have no idea.

About how much would it cost to get a tranny rebuilt?

About how much would it cost to get a tranny rebuilt?

One of the coolest induction setups I ever saw...the guy plumbed his intake hoses from the area under the cowl screen...tru cowl induction with no visible tells.

He cut two holes in the firewall and made these half-round "rain shields" to keep water out. He had the rain shields chromed so you could see them through the cowl screen. He had one more hole in the center with no hose attached and the rain shield on the engine bay side to vent the underhood air. It did a good job of keeping his windscreen de-iced in the winter too.

What exactly is cowl induction and is that an option for my car?

Man where could i find a setup like Mike P has? That would be perfect...

neone? neone?

lol not a bad idea tech