Hybrid View
-
03-31-2009 09:16 AM #1
rebuilding my fe i have a questiion
Hi i just recently decided to rebuild my 390 for my 54 merc thats been on the back burner for a while.
well i had the engine apart for years now cause at one point i thought i was gunna abandon the 390 and put a sbc. so now i decided to dig around for this stuff and i found my main caps are all out of order.
my question is what do i do about it? if the crank is cut and i get new bearings does it matter? or do i have to bolt em on and send it to a machine shop and get them bored? i dunno
thanks
Jayi want studebaker pans
-
03-31-2009 09:20 AM #2
The caps are numbered and have an arrow pointing to the front.
-
03-31-2009 09:43 AM #3
ive seen the arrow and and they all have C2AE stamped on them. where is it numbered?Last edited by bbmerc; 03-31-2009 at 09:51 AM.
i want studebaker pans
-
03-31-2009 10:00 AM #4
On the top of the cap by the arrow.
-
03-31-2009 12:38 PM #5
-
05-08-2009 02:50 PM #6
Usually there are marks from cap movement on the cap face and the block - try to match them up. Install them and see if you can feel a "step" or "edge" at the parting line
-
05-08-2009 04:16 PM #7
Look just below that center circle in the attached picture I see 3 dots,that would indicate #3
A travel agent was sitting at his desk when he noticed an elderly couple standing outside, gazing longingly at the posters of dream vacations in the shop window. They looked sweet, and honestly, a...
the Official CHR joke page duel