In the continuing saga of lights, I decided to throw together a bracket for the single fog lamp that I had picked up from Speedway. Had a piece of 1.5"x1/2" C channel left from the deck rail, a piece of thin wall tubing, some 1/8" flat stock, and a fender washer for the raw materials

DSC01023.JPG

After a bit of measuring I ended up with this hodge podge, having decided to weld in a tab that would bolt to the under side of the frame rail, keeping the top side flush. With the way the joint fits a single 3/8" button head bolt will keep it solid. The flat part is hollow, with room to run the single power wire out of sight.

DSC01026.JPG

Bracket attached...

DSC01027.JPG

And light attached...
DSC01031.JPG

DSC01028.JPG

I think the spacing is about right, and if I decide I don't like the light the whole mess comes off with one bolt and one clipped wire, leaving a single button head bolt on the frame rail, or a hole to weld.