The tail end of this exhaust was kicking my butt for most of the day, trying to hold two pipes and mark the alignment and at some point I glanced over and picked up on the fact that the engine hoist was sitting there, with the boom capable of extending out about 3' and that gave me an extra pair of hands!
-
20200716_164924.jpg
-
The hoist for the arch, some jack stands for the tail pipe..... Tanks, INC says to leave 2" between pipes and the poly tank, mainly to keep from heating the fuel and causing stink from the vent. I'm not fixed on the 2", but I am routing my exhaust out around the end of the tank, beneath the frame rails.
-
20200716_165009.jpg
-
I'll trim that loop to a nominal 45, angle it over to align with the muffler, and add a straight section....
-
20200716_173612.jpg

Neither side is done yet, but one is close and once it's piped the other one will be easier!