Thread: Project $ 3 K Is Underway

Tweet

Tech: It can't go any lower because it is going to also form my driveshaft tunnel, and if I go any lower the driveshaft will possibly hit when the car bottoms out. It actually looks higher in the pictures than it is, and doesn't intrude on the seating because it is only 6 inches wide. There is a bottom to the hoop, I made two 3/8 x 2 inch straps across the bottom. These bolt in so I can get the shaft out if needed.

I probably won't be allowed on the strip for a lot of other reasons like blanket, roll cage, etc., so street use will be all this thing sees.

What makes that tunnel so high is that the frame is much lower than traditional T's. Being this low creates some real challenges, and will probably cause me to be very careful entering and leaving driveways. I figure the car will settle down another inch or two yet when everything is installed.


Don