27Likes
Results 1 to 15 of 1567
LinkBack URL
About LinkBacksThreaded View
-
03-04-2008 05:26 AM #9
CHR Member
- Join Date
- Sep 2007
- Location
- UPSTATE New York
- Posts
- 4,336
Randy,
Now I understand why you wanted to change the handles. The GM handles must have looked clunky in today's world.
I at least partially agree with Dave S (Again!). I used this tool, below, when I did my '31 Slant Windshield Fordor. It worked great on the 70 plus year old screws though you will work up a sweat and give the 2# hammer a work out. And as far as using SS screws there, I probably wouldn't. The OEMs are most likely 5/16-24 modified flathead screws, and are extremely hard material, probably at least equivalent to Gr5 or better. SS, unless you can find some after market with the modified(smaller diameter) heads, will not be fully recessed. Also, most SS screws are no better then Gr 2 material, with NF threads not really capable of holding wellLast edited by IC2; 03-04-2008 at 05:28 AM.
Dave W
I am now gone from this forum for now - finally have pulled the plug
Reply With Quote
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Sorry for your loss of friend Mike McGee, Shine. Great trans men are few and far between, it seems. Sadly, Mike Frade was only 66 and had been talking about retirement for ten years that I know...
We Lost a Good One