Thread: Exhaust Cost

Tweet

Dave

All the cat backs we have used have been mandrel bent--no convol bends--if someone wants that they can go across the street

The reason I do my own stuff is that I don't like what others do---we see lots of it here
The Mustang system I used was off my sons 04 mustang and I used it on my wifes 33---and its stainless

I find that most non ss systems are junk after a couple of years

As far as the perishable tools are concerned---bandsaw blades are ripped up pretty bad cutting thinwall tube, grinder/ belt sander discs /belts are $$$ argon is going up with all the hazmat/safty stuff, 308 rod----

Places like Burns charge $10 per inch of stainless weld on collectors/megaphones---A 3 inch tube is almost 10 inches around($100)

Jerry

Itold shopping around will be on the list for sure . I can see SS is really way out there .


Ireland home done is good and the time spent im sure you did a fantastic job . If we did this everyday it would be faster.

Jerry your right as for being in business you have to figure in cost to do it . Like IC2 has mentioned though that type and cost of exhaust is not in this budget at all.