Thread: The Roofus Special

Tweet

What do you know? The motor is back ahead of the "firewall" again. ....where it was last year!



Foot room is much nicer....again!



Just to make sure that moving the radiator closer to the spring didn't change which perch location looked best...I mocked stuff up the other ways again.





Rearward still looks best to me.

So now that I know where the radiator goes. Time to try and squeeze in the rack.

The good thing about the wide spring crossmember is that I think I can hide the rack and pinion under it.

The rack needs to go 3.5 inches forward of where it is pictured here. It will pretty much be under the radiator.





proposed cut outs



from the side



Now the REALLY fun part. Trying to figure out how to put it all together where I can pull the steering back out at a later date if I have to.

The original idea was to mount the rack on its own crossmember and the bolt the spring crossmember over the rack.

Then I thought about mounting the rack to the underside of the spring crossmember and bolting both down as a unit.

Now I'm trying tofigure out how to fish the rack into the crossmember if the crossmeber was welded in (I really want to weld it so that I can gusset up to the upper framerails next to the radiator).



That's where I am for now. I still have some more thinking to do. ...as if I haven't sat in the thinking chair enough.

Oops. I forgot to post the pics with the a-arms in the mock up.








and the passenger side arm turned upside down as a pretend upper a-arm

And a few more "car" pics.

I've had a hard time figuring out the next step. I need to figure out how to tie the spring crossmember to the upper framerails (strengthen up the whole front end, especially the mounts for the upper a-arms).

I kinda wanted to put the reinforcement behind the spring instead of in front, simply to have the spring out in the open. The only thing I can fit between the spring and the radiator would be a plate (with a strengthing rib on the top front edge), I don't think I can fit a tube of any kind in there.

Anybody think this will be strong enough? also thought about making the rib wider as it gets closer to the frame.