Ok, First off this is not the motor that i had an oiling issue with earlier this year. this is my Back up Motor. I ussed it for 10 races last year. At the end of the season it got new rings, bearings and gaskets and has not been fired since. here is what it is.
010 4 bolt main block 4.030 bore
Eagle 4340 crank 10/10
Eagle 5.7 Hbeam rods
SRP Forged pistons 12.9:1
Sealed power 1/16 1/16 3/16 race rings
Cleavite 77 H bearings
ARP bolts and studs used throughout engine. Every bolt or Stud is ARP.
Howards Billet Roller cam
Comp cams Roller lifters
Howards Rev Kit
new Double roller timing Chain with Roller cam button
New Moroso Blue printed Oil pump w/ ARP pump drive shaft
World Products Sportsman heads + .100 valves
Roller springs 1.550
Hard + .100 push rods to correct geometry.
7/16 rocker studs
1.5 Crane Gold Race Roller rockers
Stud girdles
Extra tall valve covers
Champ style 7 QT oil pan
Victor JR intake + 1"
Entire rotating assemble has a race balance.
This Motor ran flawlessly last season. But like anything i am always looking for bigger and better. So it became a back up. I am selling it to move onto a new project.
$4500 pick up only. Serious buyers are welcomed to tear this thing down to verify all parts. Like i said. it has not been fired since freshened up.
Please ask questions if you are interested. This motor was originally used with Methanol. It will work just fine on 110 race fuel also.
It is located in Chico, CA. I will not ship this. But i will load it.
Darin