Thread: 9" pinion yoke

Tweet

I need a reasonably priced SHORT 1310 pinion yoke for a 9" Ford differential. This is the 28 spline, with 1-1/16 u joint caps and approximately 3-1/4" wide.

Originally Posted by IC2

I need a reasonably priced SHORT 1310 pinion yoke for a 9" Ford differential. This is the 28 spline, with 1-1/16 u joint caps and approximately 1-1/4" wide.

Here's one for $90.99: http://www.jegs.com/i/Moser/718/PY210/10002/-1

Here's another for $75.05: http://www.dennysdriveshaft.com/p32_...10_series.html

There were some others shown when I googled, some more $$$. Didn't know they got that pricey!

Originally Posted by randyr

Here's one for $90.99: http://www.jegs.com/i/Moser/718/PY210/10002/-1

Here's another for $75.05: http://www.dennysdriveshaft.com/p32_...10_series.html

There were some others shown when I googled, some more $$$. Didn't know they got that pricey!

Randy - Thanks and yes, I did see those as well as Curries 'rebuilt' for $60 and Speedway's new one for $65
I was hoping someone here would have one that could be parted with that wasn't so dear. I guess I got spoiled by my '57 complete $150 round back, 3.70 rear end and my $125 set of 3.25 gears now in the car (it really needs the 3.70s). I'll order the Speedway yoke if no one comes through for me.

Originally Posted by IC2

Randy - Thanks and yes, I did see those as well as Curries 'rebuilt' for $60 and Speedway's new one for $65
I was hoping someone here would have one that could be parted with that wasn't so dear. I guess I got spoiled by my '57 complete $150 round back, 3.70 rear end and my $125 set of 3.25 gears now in the car (it really needs the 3.70s). I'll order the Speedway yoke if no one comes through for me.

Did you keep the 3.70's to swap back in or do you have to find those too?

Originally Posted by randyr

Did you keep the 3.70's to swap back in or do you have to find those too?

The 3.70's are the originals from the diff. Only 53 years old but in close to perfect condition as far as I can tell.

how tall would this be?I have 28 splines, small cups, but nothing 1.25 wide. what is the dimension between caps?

Originally Posted by 48fordnut

how tall would this be?I have 28 splines, small cups, but nothing 1.25 wide. what is the dimension between caps?

My screw up(now fixed) - it was supposed to say ~3.25 between caps.

I need the ht. I have all the other dimensions. ht?

Originally Posted by 48fordnut

I need the ht. I have all the other dimensions. ht?

The short version that I need is about 4" from end to end. I do have a long version on the diff, but right now it's installed and at this time that dimension is only a guesstimate at 5-5.5 inches

mine meets all specs .clean, painted gray primer,40 bucks shipped

Originally Posted by 48fordnut

mine meets all specs .clean, painted gray primer,40 bucks shipped

PM your address and I'll ship off some bucks in whatever form you want. Probably a MO or personal check if you want to wait for it to clear, is best/easiest.

pm sent

Just received the pinion yoke - It should work fine Thanks

Again, sorry about the MO screwup

glad it worked for you