Thread: 1935 Chevy Tudor Master Sedan ???

Tweet

I have a 1935 Chevy Master tudor sedan with a Mustang II front end. Would like to add power steering but was told that this modfication would be too difficult to do on this particular car. Can anyone confirm this? Has anyone done power steering on a 1935 Chevy Master tudor sedan?

This car also has suicide doors with a broken inner passenger door handle. Anyone have? Any parts suppliers phone numbers who might have these and other '35 tudor parts would be greatly appreciated.

Sorry, one more thing, am told that the '35 may be less common than other Chevy tudor sedans. Cannot find any history sources that discusses this - anyone know?

Thank You for any assistance in advance.

Thank you Denny,
Cannot figure out how to send photos.
The handle has a square hole with a screw in the top, is 6" long with a gentle curve, outer facing portion has matching grooves along the length along both the top and bottom edge. The inner side has some numbers: 3R, then a circular mark, followed by T10884.

photo. Will this work?

I did that swap on a 39 chevy pickup with the mustang II set up and a small block, piece a cake on that one, bought a rebuilt mustang II rack from NAPA (direct bolt on ) had ta get a new U-joint(different splines) got Speedways # 910-32912 $199.95 pump.pulley.bracket,resevoir kit, & their #910-32950 $ 89.95 hose kit, Bolted it all on and walla instant power steering, Like I said it was a simple chore on that one and I think your car's gotta be real similar......