Thread: Holly 4160 600cfm carb

Tweet

OK, any experts on carburator linkage setup? I have a new 350 crate engine equipped with a Holley 4160 carb. I have installed the bracket to hold the AT kickdown cable and will soon purchase a new throttle cable.... Anyone been thru this before.

What goes where? What additional fittings are needed? etc....

Any pics of carb setup available

i would go with the lokar setup. it fits and stays adjusted. the factory plastic one will pull thru when you floor it. make sure your full throttle on the carb does not exceed the throttle preasure cable travel. the trow on the holley is more than the cable will travel.