Thread: a 5.0 in a 50 ford

Tweet

Excellent job putting that big block in there Sander!!!! Looks first rate all the way!!!!

got that rad tucked in their. very nice work. i was planning on using a diferant rad but wasant sure on which one i was just gonna worry about if after i got the motor in their and seen what kinda room i had. i did figure it to be a problem when you guys said the 5.0 is longer than the flattie but i was looking at the shallow pump for clearance. but whell see. sander what size electric fans are you running?

some trucks, bronco's and vvans used different oil pans, always check before you order custom stuff

I'm sure that a 302 will fit, get a short water pump (you may have to change the timing cover) and the right oil pan and your good to go. Go with the C4 tranny they dont take near the room of a C6. When I built my 23 t I put a 351 in and my 32 has a 302 some messing around but they fit.

Sander , nice job looks great. Its good to see a Ford in a Ford .

Originally Posted by 1lowryd

thanks but i think i`ll pass the cheapest i found the book was 80 bucks and than i found an unlimited supply for 195.00. uh no i`ll just abuse the forum some more

I don't know where you were shopping, but I found it on the first hit of google for $8.98. See offering #2 here:
http://www.bestwebbuys.com/Rich_John...compare-author
If you're gonna chop it, get book offering #3 also.

looked at ebay and amazon.com. amazon was un freigin real. i tired your link but it said page cannot be displayed. ill try again later. thanks

On here for 29.95 euros ($34.05 US Dollars)
http://perso.orange.fr/rolls.pleats/cg.htm

If this doesn't work, go into any large bookstore and ask them if they can order the book. The ISBN is 1878772155.