I set aside some time today and tomorrow for the truck. I love my wife, she's doing my house and yard duties letting me spend some guilt free hours on the truck. I took the fitted floor panel patches out today, and coated them with Por 15. While I was garbed up to keep that stuff off of me, I painted some scuffed frame areas and also hit the used 9" differential and axle and brake backing plates with it as well. What a difference a little paint makes! Here are also some shots of the above, plus the gas tank in with the temp rubber lines for startup and shake down. I'm a little worried about where to run my vent line for the gas tank. Right now it's slightly below the top of the tank. Once the bed is remounted I can probably mount the breather to the bottom of it and be above the tank. I also need to put in my fuel shut off valve and mount the canister fuel filter, but am not sure if it should be mounted to the rear by the tank or if there will be room in the engine compartment once the exhaust is installed with the headers in place! We'll see. Thanks everyone for the encouraging words, and I apologise for posting the little stuff!