Thanks for the words guys. I've been blocking it for days trying to get it down so there is no excess. I'm starting to go back over it with some Evercoat glaze to fill in the pin holes and scratch marks. I try to skim the whole panel and then sand it all away until all thats left is the edges and a few small areas where it was slightly low. I use the guidecoat for the final 180 grit sand.
I'm actually going with a blood red satin finish so I figure I have to get out as many imperfections as I can. I started out with a bunch of different blocks and then I picked up some of those K-blocks, it sure has improved my results on some of the complex curved panels. I ended up going back over everything I did before. I got the Firm and Flex 9" and 16" as well as a 5":

http://www.tcpglobal.com/kustomshop/kskblock.aspx

Sean