Thread: Clip eliminator install

Tweet

Now that its warmed up enough that i can actually work in the shop i am going to install a strange c clip eliminator in my 10 bolt, instuctions seem pretty simple only thing i thought might help and possible keep possible leaks to a minumum is to make shure the fitting of the stub axle flange to the stange inner housing is tight and well sealed with silicone or even use a urethain instead of slicone in that area.
any thoughts or ideas or experinced problems to make shure all is well and leak proof

Gascacinch works pretty well for most oily or water locations. It's like contact cement, brush a thin layer and wait until it's tacky then assemble.

Key is to have the mating surfaces really clean. I use acetone (well ventilated area - we don't want to read about you in an obit!).

Regards,
Glenn