Clip eliminator install

[canadianal]

Now that its warmed up enough that i can actually work in the shop i am going to install a strange c clip eliminator in my 10 bolt, instuctions seem pretty simple only thing i thought might help and possible keep possible leaks to a minumum is to make shure the fitting of the stub axle flange to the stange inner housing is tight and well sealed with silicone or even use a urethain instead of slicone in that area.
any thoughts or ideas or experinced problems to make shure all is well and leak proof

[glennsexton]

Gascacinch works pretty well for most oily or water locations. It's like contact cement, brush a thin layer and wait until it's tacky then assemble.

Key is to have the mating surfaces really clean. I use acetone (well ventilated area - we don't want to read about you in an obit!).

Regards,
Glenn