Thanks Guys; Right now I'm just cutting them out, but I needed to know how
much to cut away. I first have to replace the the lower sections of the sheet
metal on both side. So I'm gonna cut below the bottom body lines from the
front door all the way back. Both inner and outer sheet metal is rusted thru
so that's all gotta get cut out. Then the hard part will be the drivers side
rear corner [tail light section]. That was smashed before I got the car and
is nothing but bondo. I've allready got the new piece for that from
Desert Valley, a good solid piece too no rust. So much to do not sure
where to start. On the lower skins I'm gonna cut out the side ways tear drop
shape but I'm not gonna flare the lip. The front of the bottom of the fenders
is folded under on the edge like it was done on a brake and behind the wheel
well is rolled under. Now where to start, HE! HE! HE! Kurt