Thread: Rearview mirror mounting button
Hybrid View
-
11-29-2009 09:17 AM #1
Rearview mirror mounting button
Sorry if this is a stupid question. I have a 2006 Honda Ridgeline and I want to remove the rearview mirror mounting button from the windshield. I thought about heating it but was afraid I would trash the windshield. I assume this is glued on like most vehicles. Anyone have any ideas on safely removing this device?
-
11-29-2009 09:52 AM #2
I would not heat it because you could crack the whole windsheild. Try some acetone with some q-tips.Friends dont let friends drive fords!
-
11-29-2009 11:25 AM #3
Teddy, find a windshield replacement company near you, ask them what they use when they replace one.
Mike
-
11-29-2009 03:09 PM #4
Thanks guys!
-
11-30-2009 01:31 PM #5
-
11-30-2009 01:50 PM #6
I've seen several references to applying heat with a hair dryer or a heat gun on low setting while gripping the base with pliers, applying a slight twisting motion. No open flame - too much heat too fast. Acetone is also mentioned as an alternative, and that is the "special solvent" they sell in the auto departments - paper towel below, acetone above to let it seep into the joint like penetrating oil.Roger
Enjoy the little things in life, and you may look back one day and realize that they were really the BIG things.
-
11-30-2009 02:04 PM #7
I think I'll try the heat gun set at low first. If that doesn't work, I'll try the acetone. I hate to use acetone because it can really mess up the dash if it happens to drip. I'll cover everything real good if it come to that.
This is a Honda Ridgeline and I assume it is glued on.
thanks guys.
In our neighborhood, 2 blocks down the hill was a gas station that (to me) all the cool car guys hung out there. 32 coupes, 33 & 34 Fords as well, a sweet 56 Ford Beach wagon that was setup gasser...
How did you get hooked on cars?