Thread: Disc brake question
-
08-05-2010 02:16 PM #1
Disc brake question
What is involved in adapting Ford Explorer rear discs to an early car 9 inch rear end?
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
08-05-2010 07:24 PM #2
Here`s another option http://www.midnightdsigns.com/Mustang/Rear_Brakes.htm
http://www.boyerfour.com/mustang/rea...g_ford_8_9.htm
I have one on explorer but I`ll have to find it.Last edited by 406Rich; 08-05-2010 at 07:29 PM.
Toys
`37 Ford Coupe
`64 Chevy Fleet side
`69 RS/SS
`68 Dodge Dart
Kids in the back seat may cause accidents, accidents in the back seat may cause kids, so no back seat, no accidents...!
-
08-06-2010 11:39 AM #3
As I remember . . . the Explorer backing plates have the same bolt pattern and center hole as the large bearing Torino axle housings. All you should need is a complete set of Explorer brakes and the spacer that goes between the axle bearing and the axle flange. A complete kit would look like this:
http://www.currieenterprises.com/ces...E.aspx?id=1229
The spacer is critical. If you don't use it, the axle can move in an out of the housing by about 1/4". Not good.
What I don't remember is how the brakespace offset worked out on my '34. (That's the distance between the axle housing flange and the axle flange with the axle fully inserted.)Jack
Gone to Texas
-
08-07-2010 03:10 AM #4
Thank you Henry Rifle. Since mine is probably a small bearing, I may have to do some modifications to the mounting flange.
-
08-07-2010 11:39 AM #5
WillowBilly3 you also may need to change you proportioning valve if your running front disc rear drum right now. My conversion to front disc came setup with a valve on the master cylinder to pump out more pressure to the discs and less to the drums, also came with a power assist for the disc drum setup." "No matter where you go, there you are!" Steve.
-
08-07-2010 08:00 PM #6
Thanks stovens. I am actually building a system on an all handbuilt rod. It only weighs maybe 1800# and drums would work fine but all my rear end has right now is drums and backing plates, no guts, parking brake cables ect. I have S-10 style calipers up front on Aerostar rotors mounted to an early Econoline solid axle. If I go with rear discs, I would use a 67-76 Corvette m/c and a manual proportioning valve. I have access to a couple Exploder rear ends for cheap.
And a Happy Birthday Wish for Mr. Spears. Hope you can have a great one. :)
A little bird