Thread: Engine experts........need your help again !

Tweet

i like the PC hi temp viton with the steel chimney i use them on every thing they are a 200.000 mile seal EZ . like jerry said if new guides with a 502 then its 500 body if a thin wall liner or stock then 530 body can be used a 530 cutter will be needed . i only use a solid guide for guide repair not thin wall speed linners they work ok but i am all set up for all the 502 iron or bronze and i stock 100s of them . i use alot of iron 502 guides they work fine for most stuff .mag bronze works very well but 2X the cost were some cry about the price .i have a mix of the iron guides in plane wall and spiral cut for oil hold out less wear on guilds that and snake skin valve stems remflow could be good for some free HP