Thread: Stewart Warner Tach
-
03-24-2004 09:25 PM #1
Stewart Warner Tach
I have a SW tach that I just installed, as the diagram below. Problem is that when I turn the ign. to the on position , the tach needle goes to 4000 without the motor running. I got the tach wire on the neg. side of the coil, when I take it off, the tach reads 0. I'm running a Pertronix Flame Thrower coil and a Pertronix Ignitor electronic ignition in my distributor, do I have to wire it different than the dia.???
Tom.Quote by ED ''Big Daddy" Roth, "Wot is ...is...what ain't...ain't...!"
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
Woman stops 12 ft gator with .22 pistol! "Florida Woman Stops Alligator Attack Using a small .22 caliber Ruger Pistol." Another good reason to have a concealed weapons permit. This is a story...
the Official CHR joke page duel