Thread: TH 400 question
Hybrid View
-
09-12-2014 04:11 PM #1
TH 400 question
Tearing down my TH400 to rebuild I found a small screen on the workbench, tube shaped, about an inch long, about a quarter inch in diameter. Can anybody tell me where it fell out of? Does not mention it in my manual.
-
09-13-2014 11:46 AM #2
It has been too long for me to remember.
TH400 Parts Blow Up Diagram
.Last edited by techinspector1; 09-13-2014 at 11:52 AM.
PLANET EARTH, INSANE ASYLUM FOR THE UNIVERSE.
-
09-15-2014 12:13 PM #3
Not on that diagram, not that I can see, but Im half blind. Checked two other books, no mention. Wonder if Im on the right planet....
-
09-15-2014 12:59 PM #4
-
09-17-2014 06:31 AM #5
governor tube filter screen
-
10-02-2014 02:19 AM #6
Bingo! Fourth book I looked at, governor filter. My world is saved, for now.
-
11-11-2014 06:52 PM #7
Got the th400 back together and installed in the Broncamaro. I am up against the wall here my freinds, I got no reverse and only first gear! Checked the pressure, at idle in park reading 90 psi. At 1000 rpm getting 110 psi, not steady. Reverse drops to zero. In drive I get 80 psi but no movement. Second and first I get 30 psi. Now I am hoping one of you will share some hard earned knowledge with me as the knowledge I have will fit on the head of a pin. I pulled the governor, seems ok, but Im not sure what to look for. The modulator also, when installing the modulator against the valve, is it supposed to be spring loaded? I have to push it in against a spring when I put the bolt/bracket. This is a stock tranny, no modifications. Can you guys point me in the right direction? (after the laughter dies down)
When I was about six years old, a race car on a trailer went past our house. I thought it was the coolest thing I had EVER seen! And I haven’t been the same since.That was over fifty years ago. ...
How did you get hooked on cars?