Thread: Holbart 210
-
11-05-2014 05:33 PM #1
Holbart 210
Bought a new welder, in title, was going to go to .023 wire for some sheet metal and it wouldn't feed. went to change the roller around and it is the same on both sides. All my other welders you would just flip the roller around when you changed to smaller wire. Anyone run into this? Going to email them and see what they say, just caught me by surprise.
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
11-06-2014 01:19 AM #2
Not where I can check but I think the base roller works for 0.030" and 0.035" wire. I think you'll need a new wheel to drive 0.023" wire.Roger
Enjoy the little things in life, and you may look back one day and realize that they were really the BIG things.
-
11-06-2014 05:03 AM #3
my hobart 210 will feed .023 -.030 .
-
11-06-2014 10:22 AM #4
Mine will feed .023 but you have to really crank down on the roller tension, I even made some shims to give me more tension. With that being said, your not going to like the .023 and will go back to the .035....
I tried rubber isolators between the frame and pump, but it made little difference. I don't mind spinning the motor over to refill the carb(s), it allows time to build oil pressure, jmho..
1968 Plymouth Valiant 1st Gen HEMI