The spindles are ready to go! Once these were ground down and smoothed out they look fantastic!
We also knocked off the caliper ears in preparation for the Corvette abutment brackets.
Outside view
http://images108.fotki.com/v191/phot...MVC016F-vi.jpg
Top View
http://images114.fotki.com/v145/phot...MVC019F-vi.jpg
inside View
http://images58.fotki.com/v511/photo...MVC018F-vi.jpg
Bottom View
http://images114.fotki.com/v145/phot...MVC017F-vi.jpg
Knocking off the old caliper "ears". We sawzalled the ears off at the felt pen lines.
http://images18.fotki.com/v329/photo...MVC009F-vi.jpg
All gone, blended and ready to drill and tap for 7/16-20 bolts.
http://images114.fotki.com/v145/phot...MVC011F-vi.jpg
This is the new abutment bracket in place before we did any cutting.
http://images107.fotki.com/v67/photo...MVC010F-vi.jpg
Thanks for looking.
Any thoughts on these arms?
Mark


I am open to all comments on these. I do have to admit they look very beefy. I do know there is a lot more weld and actual "arm" supporting the new location.