Well I hauled the tank home tonight for a trial fit. It is all tacked together except for the bottom panel. That was intentional so I could test fit the fuel sender. I wasn't sure if the sender arm would clear the baffles and it didn't. I had to put a bit of a notch in the right hand wall of the baffle. The tank plugged the hole just fine though and there are no fitment issues.
http://images42.fotki.com/v663/photo...MVC003F-vi.jpg
Looking at the fuel pickup underneath. The plate with the fuel bungs needs to be welded up yet.
http://images15.fotki.com/v792/photo...MVC013F-vi.jpg
Looking inside the tank at the baffles and fuel drain holes to the pick up sump. The baffle closest to us is the one I had to put a small notch into.
http://images53.fotki.com/v666/photo...MVC016F-vi.jpg
Here you can see the cover panel with the fuel sender in place.
http://images61.fotki.com/v384/photo...MVC018F-vi.jpg
http://images60.fotki.com/v224/photo...MVC020F-vi.jpg
The tank fits so Jesse can finish the welding. I will make the filler panels at the back of the floor and hopefully get the left front wheel well rebuilt next week. I took next week off so I plan to hit the van hard.
Thanks for looking
Mark