While Mel was working on the wheel well stuff I was getting the fan shroud ready to weld on the flanges. I had to cut some clearance holes to go around the hose outlets. Because the holes were real close to the edge I used one of the wood blocks I cut to guide the hole saw as it cut the aluminum sheet.
http://images109.fotki.com/v83/photo...MVC017F-vi.jpg
I used a 2 1/2" dia hole saw mounted in my Milwaukee 1/2" drill to cut the holes. Only took a minute.
http://images57.fotki.com/v81/photos...MVC018F-vi.jpg
After the cut.
http://images20.fotki.com/v681/photo...MVC021F-vi.jpg
I will get the shroud welded up next weekend. AFTER I get gas... And pull a few more practice beads.
See you then
Mark