Got out today and got the lines plumbed. This was a bit of an adventure getting the tight bends that were needed to run the lines.
I ended up making a little bending fixture to get it done. This will be pretty handy for doing the rest of the van.
http://images34.fotki.com/v1633/phot...MVC023F-vi.jpg
I made the clamp block on the mill. Both ends have their uses and I used both getting the bends into the lines.
http://images41.fotki.com/v1634/phot...MVC016F-vi.jpg
http://images52.fotki.com/v1639/phot...MVC017F-vi.jpg
The line for the rear brakes is in.
http://images52.fotki.com/v1639/phot...MVC020F-vi.jpg
And here is the line for the front brakes.
http://images51.fotki.com/v1638/phot...MVC006F-vi.jpg
This is one of the double flares I do with my CPP Flaring tool.
http://images34.fotki.com/v1633/phot...MVC003F-vi.jpg
Got a lot done today and I am pretty pleased with the bending fixture.
Mark